Tele Neck Pup Verification

[Chin Ho]

Hello all, first post here..

I think this is a QP but the sticker "3" has me wondering; it's not what seems to be the typical SD identification sticker and I'd like to verify what I have before finishing my build. The Ohm reading is right on for a Tele neck QP. Thanks!

 

[jeremy]

looks like a qp tele neck to me. model number is str-3 so the sticker makes sense

 

[donaldr]

I think Quarter Pound pickups werenamed because of the individual 1/4" alnico 5 magnets.
I know nothing about the QP Tele neck but the obvious would be to measure if the magnets are 1/4"?

 

[Chin Ho]

I think Quarter Pound pickups werenamed because of the individual 1/4" alnico 5 magnets.
I know nothing about the QP Tele neck but the obvious would be to measure if the magnets are 1/4"?

Not even close:

 

[jeremy]

the bridge pup has 1/4" alnico rods, the neck has 3/16" or something like that

 

[Chin Ho]

the bridge pup has 1/4" alnico rods, the neck has 3/16" or something like that

3/16" of an inch. Check.

 

[Chin Ho]

So.. nobody seems too concerned that a typical SD QP Tele neck ID looks like this:


And mine looks like this?