Masta' C
Well-known member
Re: This is happening...
The factory setup is in spec according to my handy measuring tools. However, the bridge seems REALLY low compared to my other tune-o-matic equipped guitars. I'd estimate less than a full turn before being bottomed out, especially on the treble side.
I also noticed that the two set screws that lock the Tonepros bridge in place were loose. I managed to snug them up a bit, but it's very difficult to get to them with the bridge that low because of the pickup ring, which is why I'm guessing they weren't tightened from the factory.
:dunno:
The factory setup is in spec according to my handy measuring tools. However, the bridge seems REALLY low compared to my other tune-o-matic equipped guitars. I'd estimate less than a full turn before being bottomed out, especially on the treble side.
I also noticed that the two set screws that lock the Tonepros bridge in place were loose. I managed to snug them up a bit, but it's very difficult to get to them with the bridge that low because of the pickup ring, which is why I'm guessing they weren't tightened from the factory.
:dunno:
Last edited: