Despised
New member
Hello again all,
Just when I thought I wouldn't be buying any new gear this year, I was adly mistaken seeing the new stuff coming from ESP. But that is for another thread later on. This is to see if someone can help me to figure out how to get a single Fishman Fluence Modern 7 Alnico To get wired for a really unique and specific wiring/switching configuration... What I am looking to get is as follows:
Switching per 5-way switch (using DiMarzio EP1112 multi-pole 5-way switch...)
*Position 1: Humbucker in voice #1
*Position 2: Split Coil mode on Inside Coil
*Position 3: Humbucker in -6dB less gain (voice #1...)
*Position 4: Split Coil mode on Outside Coil
*Position 5: Humbucker in Voice #2
Single Master Volume push/pull pot set for:
*Down position: High Pass Filter On
*Up position: High Pass Filter Off
(I will revert back to a standard volume pot should I nkt like or care for the High Pass Filter tones...)
I know, really pulling the most out of this pickup for a minimal control pattern. But I like to pull as much tonality out of it as I can. So with this being the case, can anybody tell & show me how this can be done??? Mr Frank Falbo, any insight as to how this can be done??? I had sent an email to Fishman's support department, but have yet to hear something back about it.
Any insight will help, especially with a diagram so I can do it myself and not have to have a shop do it.
Thanks everyone!
Just when I thought I wouldn't be buying any new gear this year, I was adly mistaken seeing the new stuff coming from ESP. But that is for another thread later on. This is to see if someone can help me to figure out how to get a single Fishman Fluence Modern 7 Alnico To get wired for a really unique and specific wiring/switching configuration... What I am looking to get is as follows:
Switching per 5-way switch (using DiMarzio EP1112 multi-pole 5-way switch...)
*Position 1: Humbucker in voice #1
*Position 2: Split Coil mode on Inside Coil
*Position 3: Humbucker in -6dB less gain (voice #1...)
*Position 4: Split Coil mode on Outside Coil
*Position 5: Humbucker in Voice #2
Single Master Volume push/pull pot set for:
*Down position: High Pass Filter On
*Up position: High Pass Filter Off
(I will revert back to a standard volume pot should I nkt like or care for the High Pass Filter tones...)
I know, really pulling the most out of this pickup for a minimal control pattern. But I like to pull as much tonality out of it as I can. So with this being the case, can anybody tell & show me how this can be done??? Mr Frank Falbo, any insight as to how this can be done??? I had sent an email to Fishman's support department, but have yet to hear something back about it.
Any insight will help, especially with a diagram so I can do it myself and not have to have a shop do it.
Thanks everyone!
