Wiring Diagram for SSL-4 Tapped? Push/Pull

[EPV5150]

Hello folks!

I purchased 2 quarter pound SSL-4 tapped but I do not know installing this "tapped" on a push/pull pot.

Anyone has a wiring diagram for this installing?
Is simple?

Sorry my english is bad!

Thanks!

 

[jeremy]

Re: Wiring Diagram for SSL-4 Tapped? Push/Pull

welcome to the forum! your english is fine

you can wire both pups to one push/pull if you like. this diagram is for a tele but it shows how to wire the push/pull to tap both pups at the same time.

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=tele_2_taps

 

[EPV5150]

Re: Wiring Diagram for SSL-4 Tapped? Push/Pull

welcome to the forum! your english is fine

you can wire both pups to one push/pull if you like. this diagram is for a tele but it shows how to wire the push/pull to tap both pups at the same time.

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=tele_2_taps

Thank you jeremy!!

I thought it was more difficult!

 

[EPV5150]

Re: Wiring Diagram for SSL-4 Tapped? Push/Pull

One more question:

I received my body on last week and now I will install these pickups!

I can use this "tap" (red wire) on blender pot? Or is necessary push/pull or mini switch? I prefer this blender.

Which diagram can I use?

Thanks again!!

 

[Mark Cearlock]

Re: Wiring Diagram for SSL-4 Tapped? Push/Pull

You can use a blend pot, but only on one pickup per Blend pot.
Just run the white wire on one outside lug, and the red wire on the other outside lug with the output to switch on the middle lug of the pot.

 

[EPV5150]

Re: Wiring Diagram for SSL-4 Tapped? Push/Pull

Two blend and no tone is not interesting, but.. If I use this pot?

http://www.guitarpartsresource.com/images/large/EP-6386-000.jpg

 

[Mark Cearlock]

Re: Wiring Diagram for SSL-4 Tapped? Push/Pull

That would work, I believe, just fine

 

[ItsaBass]

Re: Wiring Diagram for SSL-4 Tapped? Push/Pull

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=tele_2_taps

You can also have independent taps if you slightly modify that diagram. To do it, install two push pulls, with one pickup going to each. You will end up with one row of three unused lugs on each switch.