Wiring diagram needed

[mlaursen35]

I need some advice (Wiring diagram) for this setup. I ordered a set of Labrea Tele pickups for the neck & Bridge, and a Red Devil for the middle pickup. The controls are below. 5 position Rotary switch (each pickup on its own, along with the neck/bridge pairing and Middle/bridge pairing. ) tone pot for the red devil is a push pull to split the coils. I want the second Tone pot to control the neck/bridge pickups. I did consider a 6 position switch to allow a neck/red devil pairing, but I don't know how feasible it is.

Thank you in advance.

 

[Chistopher]

The Red Devil is going to overpower the other pickups, are you sure this wiring is what you want?

 

[mlaursen35]

The Red Devil is going to overpower the other pickups, are you sure this wiring is what you want?

Is that significant of a difference, I think the stacked were that aggressive

 

[jeremy]

the red devil is a side by side coil, strat sized humbucker. a stacked pup has coils on top of each other.

that said, the red devil neck or middle pup should be a fine match for what you are doing. i have a red devil set and its great. the bridge is noticeably hotter and would overpower the other two pups for sure.

 

[mlaursen35]

the red devil is a side by side coil, strat sized humbucker. a stacked pup has coils on top of each other.

that said, the red devil neck or middle pup should be a fine match for what you are doing. i have a red devil set and its great. the bridge is noticeably hotter and would overpower the other two pups for sure.

The bridge would overpower the others? or the red devil would? if the bridge can hold up to the red devil, that was what I was planning, I didn't plan on pairing the neck to the red devil on a setting.

 

[jeremy]

the red devil bridge model would overpower the other pups in the middle position. i would use a neck or middle position red devil model and it should work fine