Wiring sanity check - HH on a super switch

[Securb]

I am wiring up my black Strat once again it is going to be a Dimebucker in the bridge and a Bill Lawrence L250 Stacked Humbucker in the neck. One vol no tone. What I would like to do is -

Bridge
Bridge - parallel
Both
Bridge - split
Neck

I can see the wiring in my head I am wondering if anyone has a diagram that is a good jumping-off point.

 

[Securb]

.

 

[MikeS]

Granted I'm not sure about the Bill Lawrence colors... I'm assuming the Bill/Becky 3 wire where white is typically hot and black is ground.

The only thing that isn't straightforward is the switching. I can't draw anything up right now, but I can attempt to explain it as best I can:

Jumper the common lugs of Poles 1, 2, and 3, and wire to the volume pot. Connect the common lug of Pole 4 to bridge white.
Pole 1, Jumper lugs 1, 2, 3, and 4, and connect to bridge black.
Pole 2, Jumper lugs 3 and 5 and connect to neck white.
Pole 3, Jumper from Pole 3 Lug 2 to Pole 4 Lug 1.
Pole 4, Jumper lugs 1 and 3, and connect to bridge red. Jumper lugs 2 and 4 and connect to ground.
Neck black and bridge green to ground.