I dun goofed - any help?

[Agileguy_101]

Re: I dun goofed - any help?

Since when where OP-Amps in massproduced pedals expensive?
Look like this??
No output on a religiously bypassed pedal?
Is there output in bypass??

Yeah, that's my pedal. Those trimmers are unbelievably small. I have no idea how to adjust them correctly. IIRC I get output when the effect is bypassed.

[Vasshu the humanoid typhoon]

Re: I dun goofed - any help?

Ah ok....
Hmm you have knocked the BBD's out of bias then!
Just how many of those did you turn??

Laughed so hard I nearly fell off my chair!

[GoldenVulture]

Re: I dun goofed - any help?

Ah ok....
Hmm you have knocked the BBD's out of bias then!
Just how many of those did you turn??

That picture [or a clearer one ] would help him position the trims back to where they should be.

[Dr.K]

Re: I dun goofed - any help?

I accidentally screwed with the IC trimpots on my Memory Boy, not knowing what I was doing.

Accidently? Are you sure you didn't mean purposely? Don't feel bad, I've screw up a lot of stuff by accidentally screwing with things on purpose and I've learned to fix most of it because I was to poor to pay someone else to fix it.

[Agileguy_101]

Re: I dun goofed - any help?

Ah ok....
Hmm you have knocked the BBD's out of bias then!
Just how many of those did you turn??

I tried messing with all of them once I realized that I must have accidentally bumped one of them.

That picture [or a clearer one ] would help him position the trims back to where they should be.

Maybe it's just me, but I can't see any marking on the trimmer indicating any kind of position.

[GoldenVulture]

Re: I dun goofed - any help?

I tried messing with all of them once I realized that I must have accidentally bumped one of them.



Maybe it's just me, but I can't see any marking on the trimmer indicating any kind of position.

On the part that moves [ circular piece ] there's a slight extrusion usually, which indicates the contact point. It can be used to observe where you are positioned between the two end points of the trim.

You could use that to match where they are on the pic, but it is not very clear.

If there's no extrusion, it's indicated by the shape.

Not the same trim but the best example I could find.


This has a flat edge, probably opposite the contact point. [ The above is probably at mid point. ]