1st a disclaimer: I knew this info, but somehow in all the mess of tweaking **** over the years, I forgot it.
Very important for tone considerations!
Okay, we all know (those Hotplate owners that is) the "BRIGHT" and "DEEP" switches on the front affect the tone when using the
Hot Plate in a normal config (between amp & speaker). You hit "BRIGHT" (switch up), you get more treble... you hit "DEEP" (switch up), you get more bass.
("yeah, so what?")
Well, if you use the Hot Plate as I do, the reverse is true with the switches. (IIRC, the Hot Plate manual states the same if using the line out)
To be specific, I go for a "pseudo-reactive" setup like so:
guitar
|
amp
| (amp speaker out jack)
suhr line out "speaker thru" jack (in) -> suhr line out "speaker thru" jack (out) -> hot plate (-16dB or whatever instead of "load"; the "pseudo-reactive" part) -> speaker
| (suhr line out "line out" jack)
rest of my rig and DAW
It's "pseudo-reactive" and not purely resistive because here I am not using the Hot Plate as a dummy load. The amp is going through the Hot Plate to the speaker; there just happens to be a line out signal tapped. I typically set it real low (-16dB) so it's quiet.
Anyhoo, back to the main story:
I had done a tone test recently and was wondering why the overall tone sounded "flat". So I plugged my guitar in and flipped the switches up and down.
I had both switches "on" (up) instead of "off" (down). When I reversed, I had more bass and more treble.
End result: A lot more livelier tone. Previously, it was "flat" and 2D sounding.
Very important for tone considerations!
Okay, we all know (those Hotplate owners that is) the "BRIGHT" and "DEEP" switches on the front affect the tone when using the
Hot Plate in a normal config (between amp & speaker). You hit "BRIGHT" (switch up), you get more treble... you hit "DEEP" (switch up), you get more bass.
("yeah, so what?")
Well, if you use the Hot Plate as I do, the reverse is true with the switches. (IIRC, the Hot Plate manual states the same if using the line out)
To be specific, I go for a "pseudo-reactive" setup like so:
guitar
|
amp
| (amp speaker out jack)
suhr line out "speaker thru" jack (in) -> suhr line out "speaker thru" jack (out) -> hot plate (-16dB or whatever instead of "load"; the "pseudo-reactive" part) -> speaker
| (suhr line out "line out" jack)
rest of my rig and DAW
It's "pseudo-reactive" and not purely resistive because here I am not using the Hot Plate as a dummy load. The amp is going through the Hot Plate to the speaker; there just happens to be a line out signal tapped. I typically set it real low (-16dB) so it's quiet.
Anyhoo, back to the main story:
I had done a tone test recently and was wondering why the overall tone sounded "flat". So I plugged my guitar in and flipped the switches up and down.
I had both switches "on" (up) instead of "off" (down). When I reversed, I had more bass and more treble.
End result: A lot more livelier tone. Previously, it was "flat" and 2D sounding.
Comment