I have blackouts in my Schecter C-7 standard and with my 6505 I think it's to much output to the point where it's muddy and noisy. Yesterday I put a 300k resistor between the signal wire and the output plug to lower the output. This works perfectly. I would say the Blackouts are now about as hot as a full shred set. They sound like Blackouts with more clarity and articulation IMO. And they are dead silent. I would get buzzing noise before from the insane amount of output before and I couldn't turn the gain on my amp past 2 without excess noise. This allows me to have the sustain and clarity of actives and I could open the gain up on my amp a lot more.
It's something to consider if u find the blackouts have too much output. I experimented with 100k, 150k, 200k, 400k, and 500k. I settled on 300k because it was just right for me. I'm satisfied with the blackouts now.
It's something to consider if u find the blackouts have too much output. I experimented with 100k, 150k, 200k, 400k, and 500k. I settled on 300k because it was just right for me. I'm satisfied with the blackouts now.
Comment