PART-1
Has anybody else had problems with the Series/Parallel Push-Pull function on the bridge volume pot (not the series/parallel on the triple-shot) with this diagram:
i've only check the results with a multi-meter so far. but when the push/pull is down, everything is working correctly (with the 2 triple-shot rings in series mode). however, when i pull out the push/pull to engage the series mode, everything shuts off, according to my multimeter
i've gone through my wiring over and over again, and as far as i can see, i've copied the diagram correctly. as well as adding a bridge, and tone-knob ground
PART-2
the multimeter indicates that the NECK Prail:
P90 coil = 5.39
Rail coil = 7.13
is this correct? on the bridge Prail the P90 coil 10.24, and the rail coil is 8.30
Has anybody else had problems with the Series/Parallel Push-Pull function on the bridge volume pot (not the series/parallel on the triple-shot) with this diagram:
i've only check the results with a multi-meter so far. but when the push/pull is down, everything is working correctly (with the 2 triple-shot rings in series mode). however, when i pull out the push/pull to engage the series mode, everything shuts off, according to my multimeter
i've gone through my wiring over and over again, and as far as i can see, i've copied the diagram correctly. as well as adding a bridge, and tone-knob ground
PART-2
the multimeter indicates that the NECK Prail:
P90 coil = 5.39
Rail coil = 7.13
is this correct? on the bridge Prail the P90 coil 10.24, and the rail coil is 8.30
Comment