I've seen all these tutorials on project guitar n other explanaitions. They say to loosen the plate, then tap it with a hammer n pull it out, then slide the other one in and retighten it.
Why go through all that? I tried this just to see if magnet swapping is easy.
I switched the magnets in 2 powersounds. They wouldn't tap out. Instead, i just took off the whole bottom plate and lifted them out, then put it back on. Bam. That simple. Why do they make it so complicated? Is it bad to do that? Will that not work on all pickups?
Why go through all that? I tried this just to see if magnet swapping is easy.
I switched the magnets in 2 powersounds. They wouldn't tap out. Instead, i just took off the whole bottom plate and lifted them out, then put it back on. Bam. That simple. Why do they make it so complicated? Is it bad to do that? Will that not work on all pickups?
Comment