Hi again, thanks for reading!
So here is my setup which is a bit offset from the regular and so I struggle a bit with total resistance the pup sees as well as output volume.
I'm using a vintage Maxon WRHB on the neck that clocks in at 11Khz.( Its way louder right now than the 59)
I have a 1Meg volume pot(888Khz real value), it's what I need for the Maxon.
I have a 500Khz Tone pot.
So I want first to use a resistor in parallel on the 59 so it sees 250Hz- 500Hz, I'm not too concerned about the 59 being too bright on 500K.
I would like the middle position not too dark!
I guess I would want a compromise on the 59 to have a brighter middle position...
Can anybody help me find a ballpark start value on the parallel resistor on the 59?
I hope this makes sense!
thanks
So here is my setup which is a bit offset from the regular and so I struggle a bit with total resistance the pup sees as well as output volume.
I'm using a vintage Maxon WRHB on the neck that clocks in at 11Khz.( Its way louder right now than the 59)
I have a 1Meg volume pot(888Khz real value), it's what I need for the Maxon.
I have a 500Khz Tone pot.
So I want first to use a resistor in parallel on the 59 so it sees 250Hz- 500Hz, I'm not too concerned about the 59 being too bright on 500K.
I would like the middle position not too dark!
I guess I would want a compromise on the 59 to have a brighter middle position...
Can anybody help me find a ballpark start value on the parallel resistor on the 59?
I hope this makes sense!
thanks
Comment