Why isnt this HSS wiring working?

[beaubrummels]

Well, if you removed the ground, then it shouldn't split, so you could pull the red+white off the switch and tape it off, just to see if you get full humbucking on the bridge.

[andersreve]

When I had the ground there were no sound at all...

These guys suggest that if it's not hum cancelling, to connect t7 to the hot output, what do you think?

[beaubrummels]

That will only change which coil the humbucker splits to. But you have worse problems where 3 switch positions were shutting off all sound and you weren't getting a full humbucker sound at all, if I follow your descriptions.

[andersreve]

What if I want:

Auto split in pos 2.
Tone active in 2,3,4 and 5
Neck pickup reverse wiring
Master volum
Master killswitch

Does this then make sense?

[beaubrummels]

I don't think you can tap the tone off the series link of the bridge pickup. That means the tone is acting on one coil of the humbucker and the humbucker is never split because the series link is going to the tone and not to ground or hot. I actually don't know what it will do if you connect the tone from there.