Recent content by gregory

Philadelphia Luthier Tools & Supplies now carries A5, A8 and ceramic spacer magnets. https://www.philadelphialuthiertools.com/bar-magnets/

Re: Help with wiring I'm not going to mark up that ridiculously over-complicated rat's nest, but here's a new pinout for the 5WSS if you're interested:

Re: Strat Pick-ups — Low vs High Output? Re: Strat Pick-ups — Low vs High Output? Here's a schematic... I left the tone cap at 22nF.

Re: Phat Cat + ? + Seth Lover Updated pinout:

Re: HSH wiring help Slow Sunday, I guess. Besides, I like puzzles. 1: bridge in series mode 2: bridge slug + middle 3: bridge in series + neck in series* 4: neck screw + middle 5: neck in series* (*) The push/pull will select inner slug coils on position 3 and will split the neck to the...

Re: HSH wiring help I updated the pinout to free up a pole on the 5-way...

Re: HSH wiring help I sketched this up... 1: bridge in series mode 2: bridge slug + middle 3: bridge in series + neck in series* 4: neck screw + middle 5: neck in series mode (*) push/pull on position 3 will select inner slug coils; does not affect any other position. This assumes a...

Re: HSS guitar: new Ibanez dyna-MIX9 switching - 5-Way Super Switch - 3PDT toggle Humbucker uses Duncan colors (black to hot, red/white for splitting, green and bare to ground) Hot goes to your volume control. GND is ground.

Re: Wiring help Here you go... I have the JB split so the outer screw coil is active. You'll have to reverse the hot and ground wires of the neck and bridge to keep them in phase. Splitting to the inner slug coil can also be done. In that case you would need to swap the neck and middle...

I have my Strat torn apart using a spare pickguard as a test bed for some experimentation and decided to have a look at the stock pickups while I was at it. They have non-staggered A5 rods and a weaker wind than the pre-CBS models. I never cared for the bridge pickup, but the DCR @6k suggests...

Re: Introducing from the Custom Shop: The George Lynch Hunter They look like ESP Power Rails: rounded ends with small white print centered above the top rail nearest the neck. The ones I've seen for sale were ~7k. I have no idea what gauge of wire, but to me they sound under-wound just like...

Re: Introducing from the Custom Shop: The George Lynch Hunter +1 I've heard at least one person on this forum unequivocally say that the TB-12 wasn't used on the Wicked Sensation album. If you watch the recordings of some of the actual solos that can be found on the album in his REH video you...

Re: Difference between original JB and current JB? Sorry for the resurrection, I just couldn't help myself...

Re: hh 5 way switch 1 tone 1 volume 2 push push need wiring help Here's a diagram for a Fender 5-Way Super Switch to get the following: 1: Bridge in series 2: Bridge in parallel 3: Bridge in series and Neck in series (combined in parallel) 4: Neck in series and Bridge in parallel (combined in...

Re: 1987 Charvel Model 4/6 Rewire Issue Wire each pickup, pot and switch like so: