omar___sherif
New member
I have a Taylor GS mini with a seymour duncan woody soundhole pickup (magnetic and passive), the venue i'm playing in only has passive DI boxes, I know the general rule is passive pickup to active DI and active pickup to passive DI so :
1- is it ok to plug a passive magnetic pickup into a passive DI box into the PA? or will the output be very low?
2- If i ran into an always on clean boost (Tc Spark booster 4 knobs) before the DI box would it make my signal act as if i had an active pickup? The spark has 1M ohms input impedance and 100 ohm output impedance.
To simplify here is the final signal chain i'm asking about.
Seymour duncan woody---> Spark booster (always on acting as buffer to increase output from pickup) -----> Passive DI box--->PA
So the spark will increase the output and change impedance, and passive DI box will balance the signal before the PA.
I just want to make sure that would work because i will only have a few minutes for soundcheck.
Thank you
1- is it ok to plug a passive magnetic pickup into a passive DI box into the PA? or will the output be very low?
2- If i ran into an always on clean boost (Tc Spark booster 4 knobs) before the DI box would it make my signal act as if i had an active pickup? The spark has 1M ohms input impedance and 100 ohm output impedance.
To simplify here is the final signal chain i'm asking about.
Seymour duncan woody---> Spark booster (always on acting as buffer to increase output from pickup) -----> Passive DI box--->PA
So the spark will increase the output and change impedance, and passive DI box will balance the signal before the PA.
I just want to make sure that would work because i will only have a few minutes for soundcheck.
Thank you