ehdwuld
A Ficus
So i got a sweet Ibanez Twelve String last summer
but it took a bang in shipping and lost a fret marker
it was too nice to send back
I thought about trying to match it with something else.
Then thought hey i can do it better
I can get glow in the dark 3D print filament and make it glow.
Then i thought heck lets change them all
The ones beyond the 12th fret were too hard to get to so i stopped there
I got a small hand drill off Amazon, match the drill size with the filament. Did a test on a bench in the yard.
it really doesn't take much ro drill out the markers . Just start on top of the marker and go slow , you will see the white mrker in little curls
Not super deep either
my hand started to cramp after four so take your time
A spot of wood glue on a plate was all i needed
Slip into the hole and cover with tape to clamp it till the glue dries
I left a quarter inch sticking out for for the clamp
When it dries im the morning i will trim it with my little flush cutters and sand it wit an Emory board
Ill post pics in a bit
but it took a bang in shipping and lost a fret marker
it was too nice to send back
I thought about trying to match it with something else.
Then thought hey i can do it better
I can get glow in the dark 3D print filament and make it glow.
Then i thought heck lets change them all
The ones beyond the 12th fret were too hard to get to so i stopped there
I got a small hand drill off Amazon, match the drill size with the filament. Did a test on a bench in the yard.
it really doesn't take much ro drill out the markers . Just start on top of the marker and go slow , you will see the white mrker in little curls
Not super deep either
my hand started to cramp after four so take your time
A spot of wood glue on a plate was all i needed
Slip into the hole and cover with tape to clamp it till the glue dries
I left a quarter inch sticking out for for the clamp
When it dries im the morning i will trim it with my little flush cutters and sand it wit an Emory board
Ill post pics in a bit








