Auto split with a push pull coil tap

[RockinProf]

Hi all,

Maybe I've missed something obvious, but is there a way without added relays, and a flux capacitor to have an autosplit humbucker in the bridge and a push pull pot that is coil split when using a conventional CTS five way? The end product I want is - position 5 = bridge humbucker (push pull down)/single coil from humbucker(push pull up), position 2: bridge single coil from humbucker plus middle single regardless of the pushpull pot.

Thanks!

 

[Clint 55]

Re: Auto split with a push pull coil tap

Do your auto split diagram:

https://www.google.com/search?q=aut...hUH1WMKHfn0DOIQ9QEIMTAD#imgrc=Po4E9CLCwuvbUM:

And then run a wire from the red and white on your auto split to your push pull split diagram:

https://www.google.com/search?q=spl...hVR5mMKHa94C6AQ9QEILTAB#imgrc=FTfBEIVfEy5DVM:

 

[RockinProf]

Re: Auto split with a push pull coil tap

Do your auto split diagram:

https://www.google.com/search?q=aut...hUH1WMKHfn0DOIQ9QEIMTAD#imgrc=Po4E9CLCwuvbUM:

And then run a wire from the red and white on your auto split to your push pull split diagram:

https://www.google.com/search?q=spl...hVR5mMKHa94C6AQ9QEILTAB#imgrc=FTfBEIVfEy5DVM:

Thanks, I think I tried that without success but I’ll try it again. May have been pilot error.