FS: Washburn neck and RG copy body

[t1r12003]

22 fret 25 1/2" scale length Washburn neck with locking floyd nut and allen wrench holder on the back of the headstock. Only flaw is a small chip in the finish at the headstock, and a few extra holes in the heel. Back of the neck (playing side) is perfect with a satin feel, not heavy lacquer. Standard square Washburn heel. $50 shipped in the USA

 

[t1r12003]

Re: FS: Washburn neck and RG copy body

RG copy body. This was refinished to resemble a Steve Vai swirl paint, but more streaked than swirl. It is not an Ibanez, but looks like an RG. It has an output jack in it, and the trem claw. I believe it is basswood. It has no cracks or major structure damage at all, but there was a little chipping out at the trem stud/post area where the anchors were pulled. Again, no major structural damage.

It fits a 21 fret neck or a 22 fret neck with the slight overhang of the fretboard, that's what I had on it.

A cool looking body, or refinish it for a project.

$40 shipped in the USA.

 

[t1r12003]

Re: FS: Washburn neck and RG copy body

I'm going to post these on auction tomorrow if there's no interest.