G-major And FCB1010 Midi Programming

[HolyDirt]

Hey guys, I understand how to do program changes and such with the g-major and behringer fcb1010, but can someone tell me how to do parameter changes using cc commands? Also, On buttons 1-5 on the fcb1010, how do you signal a program change, one of the 1/4" switches, and cc command(using one of hte expression pedals)? I got the switch and the program change, but cant get the cc command to work at the same time as well...

EDIT: ok, i figured out how to do parameter changes and how to get a switch, a program change, and cc command at the same time, but can i have both expression pedals controlling different parameters at the same time? how? How can i make a volume control out of one of the expression pedals? On the g-major, how do you control an effect preset's output volume? THANKS

 

[HolyDirt]

Re: G-major And FCB1010 Midi Programming

oh ya, bump

 

[Mincer]

Re: G-major And FCB1010 Midi Programming

join the FCB yahoo group, they have an extensive FAQ, lots of helpful people, and best of all, a *software editor!* Lots of info there about it working wit ha G Major too.

 

[HolyDirt]

Re: G-major And FCB1010 Midi Programming

join the FCB yahoo group, they have an extensive FAQ, lots of helpful people, and best of all, a *software editor!* Lots of info there about it working wit ha G Major too.

I am :laugh2: . That helped me figure out the other stuff, but i still cant get this... oh, and my soundcard doesnt have a midi output, so i cant use the software :smack:

 

[Mincer]

Re: G-major And FCB1010 Midi Programming

Does it have a joystick port? You can buy a midi interface- also, you can get a USB midi interface as well. Certainly worth it to program this pedal.
I don't have a GMajor, but usually volume is controlled by CC #7..assign the pedal to the same channel as the Gmajor, then assign it to control CC #7.
Make sure both pedals are calibrated and you have the latest firmware.

 

[Robert S.]

Re: G-major And FCB1010 Midi Programming

There is an "Access All" button just to the left of the G Majors display. This is where you find the output for any selected patch. The G Major is set at the factory for -6 db for each patch selected, allowing you to use a CC for lead boosts.

There is also a midi/utility button on the G Major. This is where you will find the program mapping and other midi parameters for program and CC changes.

Good luck. The G Major manual is a fairly easy read, the Berringer manual takes a bit more effort.

 

[HolyDirt]

Re: G-major And FCB1010 Midi Programming

thanks guys, that did it!!! I picked this up WAY faster than i thought i would. By the way, the g-major and fcb1010 are a match made in heaven! thanks again! I'M GONNA GO JAM!