Have you ever been in pickup-swap hell?

[Artie]

I did several swaps into my little Peavey Rockmaster. (Single bridge pup.) All were decent, but not perfect. I know I did a GFS Dream 180 which was sweet. A Nazgul, that I didn't like. And something else that I can't remember. I ended up with Jason Becker Perpetual Burn, which I believe is the keeper. Killer pup.

 

[chadd]

I went through a bunch of pickups on one of my Kauer Banshees, and finally used some pretty extreme pole heights to get where I could be happy

 

[ItsaBass]

Did you repaint it a solid color? Or do the pickup rings hide the hack job.

The answers are in the post I already made.

It's a "Black Beauty" – already an opaque color.

The wood removed was all under the rings. But even with the rings off, you can't tell anything was ever done to it.

I used the word "hacked" figuratively. The wood removal was fairly controlled, done with a small, sharp hand chisel. I only shaved off enough of the humbucker ring mounting platforms to fit P90s with goof rings.

To fix, I made a custom router template that completely removed the entire height of the ring mounting platforms – all the way down to the bottom of the stock pickup cavity. In other words, I routed out to a simple rectangle. that included just barely routing off the original finish in the bottoms of the cavities. Then glued in oversized "towers" of maple-topped mahogany to replace them. I leveled the newly installed "towers" with the top of the guitar. Then I routed with a regular humbucker routing template (also homemade). Then I masked and sprayed black lacquer, and polished to blend. Voila. Like new. The new wood joints and masking lines were exactly where the edges of the pickup rings sit. The rings mar the lacquer anyhow, completely hiding the joints (which were blended in 90 percent invisibly anyhow).

The hardest part was properly and firmly shimming the homemade router templates, so they sat at the perfect angle on the carved top. Very frustrating and exacting process. But it just took lots of time and patience.

 

[Mincer]

I swapped several pickups in my Music Man SUB1 guitar, and nothing worked. I then realized to go with what the guitar needs (pickups with no mids) rather than what I thought I wanted. I ended up with a Custom 5 and Jazz.
A Steinberger (not the one in my avatar) went through a lot of swaps- it came with cheap Epiphone Probuckers. I used P-Rails, Steve Morse models, Alnico II Pros, and more. I then realized it was the guitar I didn't like and traded it away (for the Music Man in the first paragraph).

 

[Dave Locher]

I think I went through literally 8 or 10 bridge humbuckers in my scratch-built semi-hollow. Finally decided it was "perfect enough."

 

[Synapsys]

Have you ever bought a guitar where you didn't have to change them?

My 2011 Gibson Les Paul Traditional. After reading on the Classic 57+ was thinking to go A2Pro on it, but they sound truly amazing in this LP.

Otherwise, I usually swap whatever is stock, since from overall specs I know what Duncans will fit best. So far, all Duncan swaps worked wonderfully, even if the guitar came stock with Duncans.