JB and Jazz Seem quiet, any suggestions ?
- Thread starter 80s
- Start date
Zhangliqun
Questionologist
Re: JB and Jazz Seem quiet, any suggestions ?
If you never intend to use these pickups as anything but full-on humbuckers, they don't go anywhere. They just serve as the link between the two coils so just put tape over the exposed wire so it doesn't short out the signal, the end.
Otherwise, the intention of 4-conductor humbucker leads is you can wire it to a switch with the black lead on one side and the red-and-white combo soldered to the other and you can select between single-coil or full-humbucker.
I'm reading a lot of posts in here like this lately but I don't understand why because a pink slip of paper with the color code and wiring diagram is included inside every SD pickup box. It should be pretty easy from there, unless you bought these pickups used.
80s said:
If you never intend to use these pickups as anything but full-on humbuckers, they don't go anywhere. They just serve as the link between the two coils so just put tape over the exposed wire so it doesn't short out the signal, the end.
Otherwise, the intention of 4-conductor humbucker leads is you can wire it to a switch with the black lead on one side and the red-and-white combo soldered to the other and you can select between single-coil or full-humbucker.
I'm reading a lot of posts in here like this lately but I don't understand why because a pink slip of paper with the color code and wiring diagram is included inside every SD pickup box. It should be pretty easy from there, unless you bought these pickups used.
Last edited:
