Metalplayer96
New member
is it ok to mix a passive and an active?
i want to use both in my set up.
i want to use both in my set up.
mixing passives and actives?
- Thread starter Metalplayer96
- Start date
TattooedCarrot
New member
Re: mixing passives and actives?
EMG will tell you that you need special switching, which they sell. However, I have had a couple guitars using an EMG in the bridge and a Duncan neck. Just wire each pickup separately to their own controls, then join them at the EMG stereo input jack and it works fine. I actually had my tech do it, not sure where the battery was connected in all that, but it was all good.
EMG will tell you that you need special switching, which they sell. However, I have had a couple guitars using an EMG in the bridge and a Duncan neck. Just wire each pickup separately to their own controls, then join them at the EMG stereo input jack and it works fine. I actually had my tech do it, not sure where the battery was connected in all that, but it was all good.
GHWelles
New member
Re: mixing passives and actives?
Active and Passive are mixed in the Washburn PTK with no special switching and the battery is activated by the single input jack. http://www.washburn.com/news/reviews/ptk_rev.htm
Active and Passive are mixed in the Washburn PTK with no special switching and the battery is activated by the single input jack. http://www.washburn.com/news/reviews/ptk_rev.htm
Similar threads
