Mustang Wiring help needed

[jrferguson]

I am building a Mustang and need some help with wiring it. A diagram would be MOST APRRECIATED!!!!

I am putting in a SD Cools Rails in the neck position and a SD Hot Rails in the Bridge position.

As for the 3 position switches:

The front switch I want to be a PUP selector switched all the way toward the neck I want it to select the neck PUP in the middle both PUPs in the rear the bridge PUP.

The rear switch I want to use for coil splitting the PUPs. Switched toward the neck I want outside coils, in the middle I want inside coils and in the rear position I want humbuckers fully engaged.

Stock volume and tone controls.

Any assistance would be most appreciated!!

 

[Funkfingers]

Re: Mustang Wiring help needed

Your circuit will require an on/on/on DP3T slider switch for the pickup selector.

I do not think that there are enough contacts on the DP3T to engage the coil taps in the order that you suggest and still get the pickup outputs to the control pots.