Need help on a Fender SCN+Seymour SHR-1 diagram

[Bigguy1305]

Hi.
I'm on my 8th project and would like some help on how to wire a Fender SCN n+m and a Seymour Duncan Hot rails bridge. I know the green and black on the Fender go to ground. On the Hot Rails, the red and white get soldered together and taped. The green and bare go to ground. My question is. What should I use to get them all hum cancelling or are they going to be hum cancel, a 5 way switch or a super 5. Also I would like in pos 4 for neck and bridge not middle and bridge. I'm going to do a treble bleed in series on my 300k vol pot with a 100k res and a .001 cap, a 250k 1tone and a 250k no load 2tone. It's going to be on an alder body I'm making with a ziricote fretboard and flame maple neck. All white with black hardware. I found out Adrian Smith has a signature model with Jackson that looks close to what mine's going to look like. Any help would be great.
Thanks

 

[jeremy]

Re: Need help on a Fender SCN+Seymour SHR-1 diagram

they will all be humcancelling.

you wont be able to use a normal 5way switch to get the neck and bridge in pos 4

 

[Bigguy1305]

Re: Need help on a Fender SCN+Seymour SHR-1 diagram

ok i guess im going to have to go normal on this setup. i can live with that on this one. can you check my other thread on another issue i have on one of my other guitars.

https://forum.seymourduncan.com/showthread.php?t=215676

 

[Bigguy1305]

Re: Need help on a Fender SCN+Seymour SHR-1 diagram

since its going to have fender and seymour duncans pickups. do i need to swap hot with ground on one of them or should they work fine grounding everything to where it needs to be soldered.

 

[jeremy]

Re: Need help on a Fender SCN+Seymour SHR-1 diagram

you probably need to swap the hot and ground. fender and duncan pups are usually out of phase, switching the wires puts them back in phase. each pup will sound fine individually but when on together they will sound weird if they are out of phase.

 

[Bigguy1305]

Re: Need help on a Fender SCN+Seymour SHR-1 diagram

on both or just one because i think i got the same problem on another rig of mine. check this forum of mine and tell me if its the same thing.

https://forum.seymourduncan.com/showthread.php?t=215676

also can u check this one as well. i'm getting low sound on my treble side on a shr-1 bridge pos.

https://forum.seymourduncan.com/showthread.php?t=214033

this is what i have so far what ground/hot do i need to change

 

[jeremy]

Re: Need help on a Fender SCN+Seymour SHR-1 diagram

just on the duncan, if you swapped wires on both then youd be in the same boat. gimmie a couple and ill check the other threads

 

[Bigguy1305]

Re: Need help on a Fender SCN+Seymour SHR-1 diagram

so i should swap the green with the black and i should be ok