Need Help with soldering LTD Lynch Guitar pickups

[Spooky68]

I need some help. I purchased an LTD George Lynch Tiger guitar. It had cheaper pickups on it, so I'm replacing them with updated Seymour Duncan ones. The bridge pickup was replaced with a Screamin Demon Humbucker SH-12. But now I'm replacing the neck with a Lil' Screamin Demon SLSD-1. So With the SLSD-1 it has 4 wires. White, black, red, green. The old single coil pickup had only 2 wires. White and Black. (those 2 are the white and black wires in the attached photo. Its the 2 wires on the left) So with the new pickup, I can solder those white and black wires to the location of the old white and black wires are. The Green wire is ground I assume, so that easy. But where does the RED one go?? This is all connected to a 500k push/pull volume knob. I tried to find a diagram on this website, but it did not have it. Can anyone help me figure this out?
Thanks

 

[hamerfan]

The wiring scheme on Duncan is always the same. Black is hot, green and bare wire is ground. Red and white must be soldered together and then taped.

If i see the wiring right. You have to solder the black SD wire were the old white was, and the SD green/bare were the old black was.

 

[Spooky68]

Thanks Hamerfan. It worked.