P-Rails in a Gibson Flying V?

[superfuzztone]

I just got a pair of P-Rails and would like to install them in my '84 Gibson Flying V. However, I'm not exactly sure how to go about doing this. The original schematic for the V is this:
http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_2v_1t_3w
Does anyone have a schematic for installing the P-Rails in this configuration? How about any suggestions for mods?
Cheers!

 

[Funkfingers]

Re: P-Rails in a Gibson Flying V?

Hi. If you mount the P-Rails pickups through Triple Shot surrounds, these will give you all of the coil permutations. The two conductor + shield output cabling from the Triple Shots to the control pots will comply with the SD schematic.

 

[super rad stuff]

Re: P-Rails in a Gibson Flying V?

that, or you could set up the volume push pulls to do separate splits for the p-90s and the tone to split to the rails, so you could have series/cut/parallel. that'd be the best way to do it imo, as most people want it for the humbucker and p-90 tones first, rail tone second.