Pickup Booster SFX-01 switch help!

[archelo17]

I saw a few very old posts dealing with this subject so I thought I would start a new one. I have a bad switch on my SFX-01 booster and need to replace it. I have a 3PDT (9-Pole) standard true bypass switch and need a wiring diagram to replace the stock 6-pole switch. Would anyone know how to wire it? Thanks!

 

[JacksonMIA]

Re: Pickup Booster SFX-01 switch help!

I don't have a diagram, but you should be able to just leave off one third of it. If you have a multimeter you can make notes of how the existing switch was connected and measure it and the new one to make sure you get it hooked up the same way. Just measure which ones have zero resistance (closed) and infinite resistance (open).

This, of course, is the poor man's route. I'm sure someone around here has a schematic in their library.

 

[archelo17]

Re: Pickup Booster SFX-01 switch help!

I don't have a diagram, but you should be able to just leave off one third of it. If you have a multimeter you can make notes of how the existing switch was connected and measure it and the new one to make sure you get it hooked up the same way. Just measure which ones have zero resistance (closed) and infinite resistance (open).

This, of course, is the poor man's route. I'm sure someone around here has a schematic in their library.

Thank you sir! I did exactly that today and was able to figure it out. It was actually easier than I thought. The switch is in there and working like a champ. Thanks again!