Prs wiring

[junior]

I wired my Custom 22 with a 3-way toggle, (no coil tapping or anything fancy)
and it seems to have lost some of the bite in the bridge pup position. Anyone have any ideas why?

 

[Luke Duke]

Re: Prs wiring

Did you remove the treble bleed cap on the volume pot? That cuts out some of the highs. Quite honestly I hated it and was more than glad to have it gone in my CU 24.

Luke

 

[junior]

Re: Prs wiring

I believe I did. So that causes it to mellow without it on? Can you tell me the value of the cap and where its supposed to go? Thanks a lot man!

 

[Luke Duke]

Re: Prs wiring

oh sheesh you got me there, but I'll guess.

I think it was somewhere around 2 picoFerads? I know it was something measured in picFerads, it might be after the decimal though. Aleclee will know for sure, but you can try a bunch of different ones to customize the bite.

I did the same thing that you did with yours, but my switch is where the volume was, I think I'm going to move it though to where the tone was.

Luke

 

[junior]

Re: Prs wiring

I just searched the forum and found a whole bunch o stuff. Thanks Luke!

 

[Luke Duke]

Re: Prs wiring

No problem man!