Question about the Ernie Ball EVH/Axis guitar

[ErikH]

That's what I read as well. They switched to 4C so they could use that pickup in several different Ernie Ball models.

You mentioned the 1 5/8" nut width.

I prefer 1 11/16" and if I don't play this Axis for a while the narrow nut width does take some getting used to.

I've been playing it the passed week though and now that I'm used to it, I quite like it.

That's what always happens.

When I switch back to one of my other guitars it'll take me a while to get used to 1 11/16" probably.

Do you have any idea if Dimarzio uses polished or roughcast magnets in these?

They really sound great.

Most likely polished. They don’t really stray from different magnet variations from what I’ve seen.

I like the 1 5/8” nut width on really fat necks. Like the Warmoth Boatneck contour on my frankenstrat necks but with thinner necks like Gibson’s 60’s slim I prefer 1 11/16”. Go figure. The asymmetrical profile on the Axis neck is perfect for the 1 5/8” nut. Ridiculously comfortable.

 

[jeremy]

in general i think hotter pups like that usually split well. its paf type pups that usually sound wimpy when you split them, though partial splits can be nice

 

[ErikH]

in general i think hotter pups like that usually split well. its paf type pups that usually sound wimpy when you split them, though partial splits can be nice

Agreed. However, I was pleasantly surprised how well the Whole Lotta Humbucker neck model sounds when split. It's very Strat like, almost too glassy depending on the amp settings. Sometimes I roll the tone back a bit but it has the tone and response.

 

[Lewguitar]

in general i think hotter pups like that usually split well. its paf type pups that usually sound wimpy when you split them, though partial splits can be nice

Right. Well these pickups designed with Eddie's input sound absolutely great split. Wish they were available as a set. I'd buy a set or two.