Sanity Check on P-Rail Wiring

[Bill Dennis]

OK, here's the plan

Bridge - P-Rail
middle - SSL-2 RWRP
Neck - P Rail

Going in a Player series Strat

1) I want Parallel / P-90 / Rail options on the neck/bridge positions which I believe requires a DPDT on-on-on toggle for each to accomplish
2) I want SSL-2 to hum cancel paired with the P90 coil on the bridge and the rail coil on the neck so it needs to be RWRP
3) The P90 coils combined and the rail coils combined should naturally hum cancel. Using an on/off toggle to do the Gilmour mod to facilitate those combinations
4) 500k Volume pot to get the P90's snarling. Debating using a resister to let the SSL-2 see 250k
5) 5 way switch to select positions

I think that should work but I would like some other eyes on this. I have not used P Rails previously and want to make sure this is feasible and accurate before I order parts

 

[Artie]

Chewing on it.

 

[Artie]

This is fairly straight forward. Wire up the two P-Rails to the on-on-on switches as shown. Then take your three hot wires to the 5-way and vol / tone as normal. Parallel will be with the switch in the middle position.

 

[Bill Dennis]

This is fairly straight forward. Wire up the two P-Rails to the on-on-on switches as shown. Then take your three hot wires to the 5-way and vol / tone as normal. Parallel will be with the switch in the middle position.

Perfect. That is what I expected. Thanks for confirming.

 

[Artie]

Yur welcome.