SD and Fender Pickup Phase Issue

[Victorbignacio]

Hey everyone,
I installed a SD Custom Custom on the bridge of my HSS Strat, but its out of phase with the Fender Noiseless N3 Middle Pickup.
I installed the Custom Custom the way SD diagram says, Black wire to Pickup Selector, White and Red to the Push-Pull Switch (North Coil active when splitting) and Green and Bare to ground.
What wires I should switch to have it the same way (Same sound) but in phase with the N3 Middle Pickup?
And would it switch the coil that its active when splitting?
Thanks!
Victor

 

[gregory]

Re: SD and Fender Pickup Phase Issue

- Solder the red and bare wires to ground.

- Use the white wire as your hot lead. Solder it to the 5-way switch.

- Connect the black and green wires together and solder them to the switch that does the splitting.

This will fix the out-of-phase issue and continue to use the North slug coil when splitting.