I wanted to put SDs on my Deluxe Strat. I looked everywhere for a wiring diagram. I finally called them. Included is the instruction from Brandon at SD
****
Fender S-1 Switching (for Standard 3-pickup Strat)
To put one or more Seymour Duncan humbuckers (full or ‘lil sized) into a Standard 3-pickup Strat with the S-1 switching system:
For the BRIDGE pickup:
Put the Duncan GREEN wire to the 5-way switch where the original PU's red wire went.
Put the Duncan RED & WHITE together (solder them together and tape them off).
Put the Duncan BLACK wire to the S-1 switch where the original PU's black wire went.
Put the Duncan silver (bare, non-insulated) wire to ground on the bottom of the volume pot.
For the MIDDLE pickup:
Put the Duncan GREEN wire to the S-1 switch where the original PU's yellow wire went.
Put the Duncan RED & WHITE wires together (solder them together and tape them off).
Put the Duncan BLACK & BARE wires to ground on the bottom of the volume pot.
For the NECK pickup:
Put the Duncan GREEN wire to the 5-way switch where the original PU's white wire went.
Put the Duncan RED & WHITE wires together (solder them together and tape them off).
Put the Duncan BLACK wire to the S-1 switch where the original PUs black wire went.Put the Duncan silver (bare, non-insulated) wire to ground on the bottom of the volume pot.
****
Craig
****
Fender S-1 Switching (for Standard 3-pickup Strat)
To put one or more Seymour Duncan humbuckers (full or ‘lil sized) into a Standard 3-pickup Strat with the S-1 switching system:
For the BRIDGE pickup:
Put the Duncan GREEN wire to the 5-way switch where the original PU's red wire went.
Put the Duncan RED & WHITE together (solder them together and tape them off).
Put the Duncan BLACK wire to the S-1 switch where the original PU's black wire went.
Put the Duncan silver (bare, non-insulated) wire to ground on the bottom of the volume pot.
For the MIDDLE pickup:
Put the Duncan GREEN wire to the S-1 switch where the original PU's yellow wire went.
Put the Duncan RED & WHITE wires together (solder them together and tape them off).
Put the Duncan BLACK & BARE wires to ground on the bottom of the volume pot.
For the NECK pickup:
Put the Duncan GREEN wire to the 5-way switch where the original PU's white wire went.
Put the Duncan RED & WHITE wires together (solder them together and tape them off).
Put the Duncan BLACK wire to the S-1 switch where the original PUs black wire went.Put the Duncan silver (bare, non-insulated) wire to ground on the bottom of the volume pot.
****
Craig
