Seth Lover neck/Broadcaster bridge in a tele

[cycler]

I am thinking of this combo in an ash tele, maple board...these were recommended to me over at TDPRI...has anyone here, had any experience with these two, in a similar tele...thanks in advance, emilio

ps... sorry, if this has been covered before, my first post...

 

[Curly]

Re: Seth Lover neck/Broadcaster bridge in a tele

I tried a Seth with a JD, but honestly couldn't get the Seth low enough to balance out with the JD ... the rout is almost deep enough, but you have to ground the adjustment screws down enough to get the Seth low.

no reason why it couldn't work, but I went back to a regular tele neck pup

here's a pic of that project:
http://www.bluestheater.net/seth-tele.html

 

[jeremy]

Re: Seth Lover neck/Broadcaster bridge in a tele

i tried a seth and a hot and had no volume issues, im in the process of putting a seth and a jd in a lefty tele. thanks for the tip about the rout curly. ill make sure to deepen it

 

[Curly]

Re: Seth Lover neck/Broadcaster bridge in a tele

thanks for the tip about the rout curly. ill make sure to deepen it

jeremy,
I think the rout on a US tele is OK, it's just that you have to ground down the adjustment screws.

I have an HB/ T pickguard if you need one.

 

[Dave]

Re: Seth Lover neck/Broadcaster bridge in a tele

jeremy,
I think the rout on a US tele is OK, it's just that you have to ground down the adjustment screws.

I have an HB/ T pickguard if you need one.

I agree-My MIA Fender came with a neck hum-should be plenty of room in there.