Looking forward to building an SSS with a Hot Rail Bridge and standard single style neck and middle Strat. Honestly I really dig the Factory Set in my 1999 American strat, what neck and middle would somewhat be around that sound (no hum preferred) Thanks!
STK-S4 would be Seymour's noiseless single coil to go with, or you could check out Dimarzio Areas. The Area 67 works well in neck and middle. Both sets might sound a little underpowered compared to the hot rails though, are you looking for something with more oomph than a traditional single coil?
Great and thanks for the response. What I think I will do is buy the Clsssic stack set for the neck and middle (rnrw wound) and then replace the bridge to the Hotrails. Would these be too incredibly different of a contrast? Thanks!
id wire the cs+/cs+/hr vintage style, so no tone control on the bridge pup so it stays brighter. should be a fine setup. people have been putting a hot rails in the bridge with stock single coils for years with good results. the hot rails is higher output, fatter, and darker than the singles but most people use the singles for cleaner tones and mild overdrive and the hr for more overdriven tones
Great and thanks for the response. What I think I will do is buy the Clsssic stack set for the neck and middle (rnrw wound) and then replace the bridge to the Hotrails. Would these be too incredibly different of a contrast? Thanks!
Lots of people use 2 single coil pickups with a humbucker, and this setup would be similar. You have the 2 Cassic Stacks for quacky, stratty stuff, and the Hot Rails for some serious punch for heavier rock.
The neck position picks up a lot more string movement than the bridge so tends to have more signal naturally anyway . . . so couple that with some careful pickup height adjustment and I think you could make the setup usable.