Hello everyone, first post here so I’ll make it quick. I have nice playing rg120 that I wanted to try a new strange wiring mod on. So I have a single coil in the bridge (cs69) humbucker at the neck (whole lotta humbuckers). I wanted to have a volume for both pickups no tone (two pots in total). Coil split and phase switch for humbucker with push pulls. Soooo I love stereo rigs and I always was interested by the rickensound, you see where I’m going 
so I wanted to run a stereo lead out to a splitter I’ll make later into two amps. So I was just going to take out the blade switch but I was then thinking of this configuration.
Position one (down, closer to ground) stereo pickup configuration going to stereo 1/4.
Position two: bridge only, both amps
Position three: bridge and neck, both amps
Position four: Neck, both amps
Position five (up) series wiring for pickups, both amps
I have a strat super switch around that would be perfect for this project but am very confused by the switch wiring. I have all the other wiring down and just really need help with the blade switch wiring. Let’s see you pro tinker post some pics! In the meantime I’ll try my best to figure it out.
Thanks guys!
so I wanted to run a stereo lead out to a splitter I’ll make later into two amps. So I was just going to take out the blade switch but I was then thinking of this configuration. Position one (down, closer to ground) stereo pickup configuration going to stereo 1/4.
Position two: bridge only, both amps
Position three: bridge and neck, both amps
Position four: Neck, both amps
Position five (up) series wiring for pickups, both amps
I have a strat super switch around that would be perfect for this project but am very confused by the switch wiring. I have all the other wiring down and just really need help with the blade switch wiring. Let’s see you pro tinker post some pics! In the meantime I’ll try my best to figure it out.
Thanks guys!
