Treble Bleed value

'59

New member
What's a good capacitor value for a simple treble bleed for a SSS Tele with a 250k volume and tone combo?

I'm not interested in adding any resistors just a quick and dirty capacitor.
 
200pf range is about even to my ear. 100 range maintains some treble but darkens a bit as you turn down. 300 range is if you like it bright. And 400+ is mega bright.
 
Take your pick:

Kinman 1.2nF + 130kΩ series
Suhr 680pF + 150kΩ parallel
Fralin 2200pF + 220kΩ parallel
G&L – 200 pF (no resistor)
Bill Lawrence – 330 pF capacitor & 80 kΩ parallel
Seymour Duncan – 1nF capacitor & 100 kΩ parallel
 
That's why you tell him what values work for cap only, like I did. Not give him cap + resistor combos when he didn't ask for them, and when the cap values will be too high if you remove the resistor. Cap + resistor combos have higher cap values than cap only.
 
That's why you tell him what values work for cap only, like I did. Not give him cap + resistor combos when he didn't ask for them, and when the cap values will be too high if you remove the resistor. Cap + resistor combos have higher cap values than cap only.

Then he can use the one I posted that doesn't use a resistor as an option. (Appears to be the same you posted. What is your problem?) Cap alone doesn't work well. Part of this conversation is educating - these posts will be here for other people beyond the OP that have the same question.
 
im not a fan usually, but i have one guitar that has a either 150k or 180k in there and it works as good as anything ive heard
 
It’s easy to end up with a single cap treble bleed that is too bright. Ibanez use a 330pf as a single component. I would suggest trying this and even 220pf. 220pf is my favourite, but I have a series resistor as well. I used the same value with both 250k and 500k controls, but it will be a more subtle effect with a 250k volume control.
 
Last edited:
Back
Top