maxdave2010
New member
Hi again people,
As some of you may have established, I'm an absolute beginner. I'm installing a new Seymour Duncan in one of my old guitars, and completely rewiring it in the process. And I'm doing this all for the first time. So I need a little help
Bascially - I don't have the slightest clue as to what wire to use. I dont know what gauge I should be looking for, what type of wire, anything! Also, do I need to use different wire for the grounding connections?
I'm in the UK, so I don't know if our wire gauges are different to USA gauges, so that may be an issue. But any help you can give me - and i'm sure most of you know this stuff off the top of your heads! - would be GREATLY appreciated. I don't have a clue!
For reference, the setup I'm going to install is a simple:
SD Invader -> 500k Volume Pot -> Output jack
No tone controls or any other pickups are involved.
Thanks!
As some of you may have established, I'm an absolute beginner. I'm installing a new Seymour Duncan in one of my old guitars, and completely rewiring it in the process. And I'm doing this all for the first time. So I need a little help
Bascially - I don't have the slightest clue as to what wire to use. I dont know what gauge I should be looking for, what type of wire, anything! Also, do I need to use different wire for the grounding connections?
I'm in the UK, so I don't know if our wire gauges are different to USA gauges, so that may be an issue. But any help you can give me - and i'm sure most of you know this stuff off the top of your heads! - would be GREATLY appreciated. I don't have a clue!
For reference, the setup I'm going to install is a simple:
SD Invader -> 500k Volume Pot -> Output jack
No tone controls or any other pickups are involved.
Thanks!
