Stop bar issue

[Natman]

Hey guys, I have a Fender JA90 which is a great axe but I want to change the bridge and stop tail for Tonepros. I notice the stop bar uses #24 thread but stock is #20 (I checked with feeler gauge on my tap/die set).

What can I do in such a case? I suppose the inserts have to be changed? That would mean a visit to the luthier and more $$. Is there any way around that?

 

[925SS]

Re: Stop bar issue

If you feel capable of doing the work yourself, here's a vid that will help you out
http://www.youtube.com/watch?v=RsZ9zBX2eDU
Just make sure you use a big screwdriver to keep from damaging the old studs, in caes you want to sell, or use them again

 

[AlexR]

Re: Stop bar issue

Pull the studs out and buy a tonepros tailpiece with the same width OD. I've used a clawhammer in the past with something flat on the body for protection.