DEADBYDAWN
New member
I have a Jackson Dinky with a Duncan Distortion-bridge, Jazz-neck, 3way switch, one tone and one volume pot.
I want to install new wiring, new CTS tone(w/ new orange drop capacitor) and volume pots, new CRL 3 way switch, and a new output 1/4" jack.
I am going with CTS 500K pots -3/8" split shaft.
Q#1- Are these just called audio pots and will these work for both tone and volume?
Q#2- What guage wire would be best? Would 22 gauge pvc covered wire with a copper single-conductor wire, 0.050" diameter be ok to wire everything up with?
Q#3- On the Sey. Duncan wiring diagram it says I need a .047 cap for the tone pot. Would I need a 600 volt or a 200 volt .047 cap?
Thanks in advance:cool2:
I want to install new wiring, new CTS tone(w/ new orange drop capacitor) and volume pots, new CRL 3 way switch, and a new output 1/4" jack.
I am going with CTS 500K pots -3/8" split shaft.
Q#1- Are these just called audio pots and will these work for both tone and volume?
Q#2- What guage wire would be best? Would 22 gauge pvc covered wire with a copper single-conductor wire, 0.050" diameter be ok to wire everything up with?
Q#3- On the Sey. Duncan wiring diagram it says I need a .047 cap for the tone pot. Would I need a 600 volt or a 200 volt .047 cap?
Thanks in advance:cool2: