wiring diagram for push-pull humbuckers
- Thread starter Roy G
- Start date
blueman335
Mojo's Minions
Re: wiring diagram for push-pull humbuckers
A capacitor will just filter out some of the frequencies, usually some of the highs, and won't add any volume.
What's far more useful than coil cut (what you have now) is spin-a-split. It turns the tone pot into a volume pot, so you keep part of the 2nd coil on, which has more volume, mids, and lows than coil cut, but not as much of those as full humbucker. Instead of going from 2 coils to 1 coil, you can go to 1.5 coils, or 1.75 coils, or 1.25 coils, etc. There's diagrams online for it, very quick and easy to do.
A capacitor will just filter out some of the frequencies, usually some of the highs, and won't add any volume.
What's far more useful than coil cut (what you have now) is spin-a-split. It turns the tone pot into a volume pot, so you keep part of the 2nd coil on, which has more volume, mids, and lows than coil cut, but not as much of those as full humbucker. Instead of going from 2 coils to 1 coil, you can go to 1.5 coils, or 1.75 coils, or 1.25 coils, etc. There's diagrams online for it, very quick and easy to do.
F
Funkfingers
Guest
Re: wiring diagram for push-pull humbuckers
I posted in one of the other editions of this thread. I cannot be arsed to post the same reply again.
Mods, please merge the threads.
I posted in one of the other editions of this thread. I cannot be arsed to post the same reply again.
Mods, please merge the threads.
