Recent content by Demina

Re: Need Wiring Help - JB in a Mustang I didn't shunt the red/white to ground because he wanted the south coil (outside if I'm not mistaken) to be active. With the switch down (back), the contacts on the left side will short the red/white to black, shorting out the north coil leaving only the...

Re: Wiring Confusion (50s Vintage Coil Split) What Doc said. Just move the gray wire from tone to volume in my diagram from the middle of the vol pot to the outside where the red wire is.

Re: Wiring Confusion (50s Vintage Coil Split) What you have there is the Cap and tone pot in series between the switch and the vol pot. That's going to cause the cap to block lows (depending on the value) rather than shunt the highs to ground as a normal tone circuit does. Also the tone is...

Re: Need Wiring Help - JB in a Mustang Assuming you are using the JB in the bridge position, this wiring diagram should get what you want. I am not absolutely sure which coil is the "outside" one, but I believe it is the South coil on the bridge, and that's how I drew it up. Let me know if you...

Re: HSS wiring question I can't really tell from the photo, but assuming you are using a standard 2 cap Strat wiring scheme there, this should be what you want. I have corrected it for DiMarzio colors according to SD's translation diagram.

Re: Unique wiring diagram I'm pretty sure the Gibson branded switch (PSTS-020) I put in my LP is wired like he shows there. <----Confirmed

Re: Wiring diagram request The note refers to the ground shown below left circled in red. Disconnect that and make the connection shown in red below right:

Re: Clear Toggle Rings? Let us know if you find anything out! I got some from this outfit awhile back: http://www.ebay.com/itm/310791275265?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 They don't have clear though and I don't think they look as good as the photos on eBay

Re: P90 Questions Well, I got her all together, but had a mishap so I haven't done any cap testing yet. I attempted to bend the "top" lug on the bridge tone pot a little to give me a bit more clearance for my clip lead, and the sucker broke plum off! Sophie Anne: I stole the switch plate...

Re: Triple coil pickup..? The Fender Marauder also has a TripleBucker http://www.fender.com/series/modern-player/modern-player-marauder-rosewood-fingerboard-lake-placid-blue/

Re: What do you think of these project Gibsons on eBay? I've bought two Gibsons recently from the Stratosphere, a 70s Tribute SG in historic Cherry, and a 50s Tribute LP in Wine Red. The SG which sells for $999 cost me about $750 total, and the LP ($1099 I think) will come in at about $850...

I recently got my first Les Paul. It's a 50s tribute model, bought as a project (Body and neck only). I ordered everything I figured I needed and I'm getting ready to wire it up, but I had a couple questions. The pickups I got are GFS P90s. Resitance is 8.3k for the neck and 8.5k for the bridge...

Re: Hot Rails wiring for classic player series Jaguar That SD diagram for the Jaguar is not completely accurate for the 62 AVRI, 50th anniversary, MIJ SE, Squier VM, and original 62 Jaguars, and I bet your CP is the same as the ones I listed and likely the new 65 AVRI as well. The differences...

Re: Please help me before I go on a rampage (HSS superswitch wiring) OK, I went ahead and worked something up for the following configuration: Pos1: Bridge only, Humbucking, Bridge Tone pot Pos2: Bridge Single coil/Middle, Bridge Tone pot Pos3: Bridge Single coil/Neck, Bridge Tone pot Pos4...

Re: SDUG ULTIMATE AXE - ANYTHING GOES!!!!!!! My entry, name of Simone: Body is from the GFS factory buyout sale, neck from a 2012 Squire VM Jaguar. Pickups are Lace powered. Got them from a Chinese outfit on E-bay. Bridge is a Warmoth modified Mustang. The trem is from an original ('63-'65)...