How to wire a volume and tone control bypass switch?

[bhuether]

Check this out:

Push/pull 1 is a coil cut switch that cuts both pickups simultaneously.

This should work as

Push/pull 1 down*
1 Bridge series
2 Bridge series parallel w/ neck series
3 Neck Series

Push/pull 1 up*
1 Bridge north coil
2 Bridge north coil parallel w/ neck south coil
3 Neck south coil

And then push/pull 2 when pulled up should bypass the volume and tone controls sending the pickup outputs for each of the settings above straight to the output jack.

But I am not sure about this. Can anyone tell me if this will work?

thanks,

brian

 

[MikeS]

Re: How to wire a volume and tone control bypass switch?

Yep, that's one way to wire push/pull 2 to get what you want. Push/pull 1 does not work with Seymour Duncan color codes... I assume you're using Dimarzio?

 

[bhuether]

Re: How to wire a volume and tone control bypass switch?

Meant to say the wiring is for Dimarzio!